Model specifications and parameters

The model and the specification and the single tooth are same, uses the large scale mold spiral cutting, but the bandwidth is limited to 25mm, the actual length can reach 200-300 meters.

Material selection and product characteristics

The belt body used Japanese imports of high-quality synthetic chloroprene rubber, and mixed with a variety of different uses of rubber materials; skeleton materials for high quality glass fiber cord imported from Japan; with tooth surface with high elastic nylon cloth 66 protection. The product is similar to the general synchronous belt transmission, and can be widely used in the textile, light industry, chemical industry, machine tools and other general machinery to transfer power. Customers can flexibly according to the actual needs of the length of cutting.

Related matters needing attention

1）Note that the product surface is clean, the belt should not be distorted, with teeth to be full.
2）Products in the transport, installation and other processes, no twists and turns, otherwise it will damage the skeleton material (glass fiber), the impact of the strength of the belt.
3）Products in the installation and use of the process, shall not scratch the belt, not with chemicals (especially strong oxidizing acid), try to avoid contact with oil and water for a long time, so as not to affect the life of the product.
4）When the product is replaced, the tension of the belt must be reduced to the minimum, so that it can be taken out. It is strictly prohibited to use the non professional tools to pry down under the condition of high tension.